Author: Ray62
Subject: [Help!] Asrock B450m Steel Legend
Posted: 05 Oct 2019 at 6:28pm
The WDSN500 is a drive with PCIe NVMe 3.0 x2
The storage QVL of the board does not show this SSD, but another WD device with PCIe3 x2.
Your SSD should be working in the M2_1 slot (even if that supports 4 lanes).
Normally, there is nothing special to do to get the drive working.
Double check, that the SSD is connected & mounted correctly!
Did you do what i already postet?
Is the drive then visible under Advanced\Storage Configuration?
If not, switch off, unplug the PSU and do a CMOS reset like described in the manual.
After that proceed again as i posted.
If that does not help, you have to check the SSD with another computer.
Subject: [Help!] Asrock B450m Steel Legend
Posted: 05 Oct 2019 at 6:28pm
The WDSN500 is a drive with PCIe NVMe 3.0 x2
The storage QVL of the board does not show this SSD, but another WD device with PCIe3 x2.
Your SSD should be working in the M2_1 slot (even if that supports 4 lanes).
Normally, there is nothing special to do to get the drive working.
Double check, that the SSD is connected & mounted correctly!
Did you do what i already postet?
Is the drive then visible under Advanced\Storage Configuration?
If not, switch off, unplug the PSU and do a CMOS reset like described in the manual.
After that proceed again as i posted.
If that does not help, you have to check the SSD with another computer.